NAME    DIR   NOTES
   ----    ---   ------------------------
   DRDY*    O    Output-data-ready signal to parallel device in
                 output mode, used in conjunction with ACK* (pin 10)
                 for a two-line asynchronous handshake.  Functions
                 as input data accepted from Amiga in input mode
                 (similar to ACK* in output mode).  See  timing diagrams 
                 in the following section.
   D0      I/O   +
   D1      I/O   |
   D2      I/O   |
   D3      I/O   | D0-D7 comprise an eight-bit bidirectional bus
   D4      I/O   | for communication with parallel devices,
   D5      I/O   | nominally, a printer.
   D6      I/O   |
   D7      I/O   +
   ACK*     I    Output-data-acknowledge from parallel device in
                 output mode, used in conjunction with DRDY* (pin 1)
                 for a two-line asynchronous handshake.  Functions as
                 input-data-ready from parallel device in input mode
                 (similar to DRDY* in output mode).
                 See  timing diagrams .  the 8520 can be programmed to
                 conditionally generate a level 2 interrupt to the
                 680x0 whenever the ACK* input goes active.
   BUSY    I/O   This is a general purpose I/O pin also connected to a
                 serial data I/O pin (serial clock on pin 12).
                 Note: Nominally used to indicate printer buffer full.
   POUT    I/O   This is a general purpose I/O pin to a
                 serial clock I/O pin (serial data on pin 11).
                 Note: Nominally used to indicate printer paper out.
   SEL     I/O   This is a general purpose I/O pin.
                 Note:  nominally a select output from the parallel
                 device to the Amiga.  On the A500/A2000 also shared
                 with RS232 "ring indicator" signal.

   RESET*   O    Amiga system reset